Proudly headquartered in Valley City, Ohio, and with multiple manufacturing locations across the country, including Ohio, Kentucky, Tennessee and Mississippi, Troy-Bilt is strongly committed to the communities we're a part of and keeping America working as hard as we can.

The inner reel and any pieces of Old Line. Cut one 12 inch length of trimmer. Line. The middle and bend it into a loop slip it into the slot on the Reel. And wind the line around. It.

Now install the new trimmer head and again remember it is a reverse thread. I'll lock the spindle in place and tighten up the head. And I'll finish up by reattaching the trimmer attachment.

And you're ready to trim. And remember look for the press to start logo when searching for electric. Start products at your local Troy Bilt retailer.

MTD's regional brands include Troy-Bilt® in the Americas, Rover® in the Pacific, and WOLF-Garten® in Europe. The portfolio also includes Remington®, Yard Machines®, Columbia®, and MTD Genuine Parts® brands, all primarily sold in the Americas; and Robomow® which is sold in the Americas, Europe and the Middle East.

Troy-Bilt® is headquartered in Valley City, Ohio, and our reliable equipment includes select products that are designed, built and tested right here in the U.S. – from Ohio and Mississippi to Tennessee and Arizona.

Position. And activate the choke. Turn the key to the start. Position once the mower has started release the key and allow it to return to the on. Position. Now move the throttle to the rabbit.

Thread each end of the line through the eyelets on the trimmer head as you connect the spool and bump knob wind the bump knob based on the arrows shown on the reel. Apply pressure to wind it evenly.

In bump feed systems, varied lengths of line are wound around the spool of the trimmer with two equal lengths fed through openings in the trimmer head. These systems work by lightly tapping or “bumping” the bottom of the trimmer on the ground while you're trimming.

Sides. So once you have it even on both sides. This is where the magic. Happens. So then a couple ways you can hold this top piece and just turn.

Position. And activate the choke. Turn the key to the start. Position once the mower has started release the key and allow it to return to the on. Position. Now move the throttle to the rabbit.

And rotate it a full 90 degrees you'll see that the strimmer head is now upright. So we need to adjust the angle of the head place a foot on the top of the head and apply a firm pressure to the shaft.