Remember always keep moving continuously while spraying. If your surface area is larger overlapping each spray pass by 50 percent will ensure full coverage. Apply a thin first coat.

When cleaning your sprayer. It's important to make sure the air tube is clean and free of paint the tube can be removed. And cleaned by turning the air valve. And moving the tube from the sprayer.

Another possibility is that the suction tube could have an air leak. First try tightening the connection to the sprayer. And if that doesn't work check it for holes or kinks.

I for paints. And more for stains on. A low power setting you'll have to move slower. And get later coverage. At full power you can move fast and apply a lot of pain changing.

Then stay well until you achieve an even consistency.

Then stir well and of course always ensure that there are no lumps in the paint. The paint now flows much faster from the stick. As you can see after dilution.

Some common reasons for a paint sprayer not priming include a clogged or dirty intake valve, insufficient paint viscosity, air leaks in the system, or a malfunctioning pump. These issues can prevent the proper flow of paint and hinder the priming process.

My sprayer sprays water but not paint? Debris is caught in the sprayer. Try reversing the spray tip 180 degrees to see is paint can be sprayed. If it can, turn the spray tip back to the spray position to spray.

If this is the issue you experience the most likely cause is that the transducer is worn out. The transducer signals to the airless pump that pressure is needed and signals to run the pump to build pressure. Failure to build pressure often indicates that you need to replace the transducer.

So check the tech sheet on the gun to see how it's supposed to be set a recommended. Air pressure you should be running after you've attached the regulator. We also recommend.

This is the first stage of the trigger. Function only allowing air through the air cap. Keep the trigger depressed like this while simultaneously adjusting the air supply regulator. On this regulator.

But. As I finish this at 40 seconds. You can see there's far too much paint in the cup. I only paint with water-based finishes. So I keep a clean container of water in my shop.